公式法的英文

發音:

英文翻譯
造句

formula method

公式 formula; expression
法 law
公式法化簡 formula method simplification
珀爾公式法 pearl formula
公式法變動預算 formula type of variable budget
多組件材料條形公式法 multicomponent material strip equation
雙金屬熱力學公式法 bimetal thermal equation
杯式法 test method for water vapor transmission of plastic film and sheet-cumethod
閉式法 closed circuit method
層式法 veils
等式法 equation method
干式法 dry method; dry process
格式法 schematized version
鼓式法 drum method
堿式法 alkali test
鏈?zhǔn)椒?/span> chain method
模式法 type method
橋式法 bridge method
濕式法 damp process
數式法 formula methods
型式法 pattern method
隱式法 implicit method
柱式法 column method
公式 formula; expression 代數公式 an algebraic formula; 硬套公式 apply formula mechanically; 公式語言 formula language; 公式主義 formularism
部分分式法 method of partial fraction

"查查詞典"手機版

千萬人都在用的超大詞匯詞典翻譯APP

例句與用法

The formula method which solves general solution of linear differential equation with constant coefficient
求常系數線性微分方程通解的公式法
Two popular ways to perform cvp analysis are the equation ap ? proach and the contribution margin approach
進行本量利分析的兩種常用方法上是公式法和邊際貢獻法。
Usually , formula method , gas reservoir driving type method and analogy method , etc . , are used to determine the abandonment pressure or recovery
通常是采用公式法、氣藏驅動類型法或比法等來確定氣藏的廢棄壓力或采收率。
In the equation approach , we start by dividing total expenses in ? to variable expenses and fixed expenses , and then express in ? come in equation form
在公式法中，我們首先將總費用分為變動費用和固定費用，然后得出利潤公式。
The main job of this dissertation is to calculate and forecast the intrinsic frequency of the typical truss mast adopting the experience formula energy and finite element method
本文的主要工作，是采用經驗公式法、能量法和有限單元法分別對桁架桅的振動特性進行研究。
In order to overcome formula inherent shortcomings of poor steady - state performance and micro - amplitude oscillation , continuous factors multiplication method is combined with formula method
同時為克服公式法所固有的穩態性能差，易產生微幅振蕩等缺點，將連續因子相乘法與公式法相結合。
Abstract : this paper mainly utilizes the methods of formula , isometric transform , cut and complement , extremes and analyzing special section to calculate the volume in solid geometry
摘要:文章探討了用公式法、等體積變換法、割補法、極值法、分析特殊截面等方法求立體幾何中幾何體的體積。
This article illustrates the judgement of veracity of the fea result using the methods of both formula and mode analysis through examples , and gives some correlative method based on experience
舉例說明了用公式法和模態分析法對有限元分析結果準確度的判定，并根據經驗列出了一些相關的判定方法。
How to decide atomic ground state problem has been studied based on lowest energy principle , hund rule , and pauli exclusion principle . it is summarized to two methods
摘要以能量最低原理、洪特定則和泡利不相容原理為依據，對原子基態的確定問題進行了研究，得到了公式法和圖表法兩種確定原子基態的方法。
According to the analysis of the table lookup , the graph method and the simulating formula method of selecting bolt diameter without controlling pretightening force under dead load were presented in this paper
摘要通過對查表法資料進行分析，提出了靜載時選擇不控制預緊力的緊螺栓聯接螺栓直徑的圖線法和模擬公式法。