例句與造句

1. All programs start with the special word begin and finish with end .
   所有程序都用專用字begin（開始）表示開始，用end（結束）表示結束。
2. Program started in 1998 and continues at present
   該項目開始于1998年，并一直持續到現在。
3. This thread executes the code in the program starting and ending with the
   此線程執行程序中以
4. This means that a program started with the
   函數啟動的程序在
5. Each time the program starts , the
   每次啟動程序時，
6. It's difficult to find program start in a sentence. 用program start造句挺難的
7. When the program starts , the
   當程序啟動時，將執行
8. Service broker does not stop a program started through activation
   Service broker不停止通過激活功能啟動的程序。
9. The test program starts
   測試程序啟動。注意，
10. Each time it is shown , the program starts a nationwide debate on the subject
    每次播放都引起對這個問題的全國性大辯論。
11. Usually , configurations that are not entirely known before the program starts
    通常是那些在程序開始之前不能夠完全理解的配置。
12. Every time it is shown , the program starts a nationwide debate on the subject
    每次節目上映時，都引起全國范圍對這個話題的討論。
13. A conference on principles and practice of declarative programming starts in june .
    一個關說明性編程的原理和實踐的會議于六月召開。
14. All programs start with the special word begin and finish with end
    所有程序都用專用字begin （開始）表示開始，用end （結束）表示結束。
15. It will automatically check whether the dog exist when the programs start running or are running
    在程式開始運行和運行當中會自動地訪問狗是否存在。
16. Parameters entered for a calibration can be saved and automatically reloaded upon the next program start
    可以保存校準所用參數，測量參數自動裝載。
更多例句：  下一頁